Battery Removal - BaByliss PRO FXFS2E Mode D'emploi

Weekly Maintenance:
1. Repeat steps 1 – 3 from the Daily
Maintenance cleaning steps.
2. Rinse the head of the shaver
under running water (see Fig. 5).
NEVER submerge the shaver in
water.
3. Leave head open for drying.
4. Press the shaver head back into
place (see Fig. 4).
Fig. 5
Washable

BATTERY REMOVAL

When your rechargeable sha-
ver reaches the end of its useful
life, the Ni-MH batteries must be
removed from the shaver and be
recycled or disposed of properly
in accordance with your state and
local requirements. If this is not
required by law, you may elect to
dispose of the shaver with the bat-
teries.
To remove the rechargeable bat-
tery:
1. Unplug the shaver.
2. Run shaver until motor stops.
3. Remove foil head from shaver
(press release button and pull
head away from shaver body).
4. Remove screw from bottom
housing. Remove 2 screws from
metal plate under cutters.
5. Remove cutters by pulling away
from drive shafts.
6. Remove on/off switch and re-
lease button by lightly prying
free with a small screw driver.
7. Slide off metal cover.
8. Remove screws holding inner
plastic casing together.
9. Pry batteries free from circuit
board and cut wires.
10. Dispose batteries.
CONTAINS NICKEL METAL HY-
DRIDE BATTERY. MUST BE COLLEC-
TED, RECYCLED OR DISPOSED OF
PROPERLY. DO
NOT DISPOSE OF IN THE MUNICI-
PAL WASTE.
CAUTION: ALL RECHARGEABLE
BATTERIES MUST BE RECYCLED
OR DISPOSED OF IN ACCOR-
DANCE WITH APPLICABLE STATE
AND LOCAL REGULATIONS. DO
NOT PUT IN FIRE OR MUTILATE,
AS THE BATTERY MAY BURST OR
RELEASE TOXIC MATERIALS. DO
NOT SHORT-CIRCUIT, AS THIS MAY
CAUSE BURNS.
12