Blower Operation - Makita EB5300TH Manuel D'instructions

► 1. Fastener
Hip belt
Optional accessory
The hip belt enables the operator to carry the
tool more stably.
CAUTION:
Make sure to release the hip
belt buckle before unloading the blower.
Adjusting the control lever position
For tube throttle model: Move the control han-
dle along the swivel pipe to the most comfortable
position. Then tighten the control handle with the
clamp screw.
► 1. Clamp screw
For hip throttle model: Move the handle
assembly along the swivel pipe to the most com-
fortable position. Then tighten the handle with
the clamp screw.
1
► 1. Clamp screw
Adjust the angle of the control arm.
► 1. Control arm

Blower Operation

1
1. While operating the blower, adjust the throt-
tle trigger / throttle lever so that the wind force is
appropriate for the work location and conditions.
2. Adjusting engine speed.
For tube throttle model: Engine speed
increases by pulling the throttle trigger. To
decrease the engine speed, loosen the throttle
trigger.
16 ENGLISH
1
1