Braking System - SXT Scooters SXT 1000 Turbo Notice D'utilisation

GENERAL
*Your SXT scooter is equipped with a variable throttle. Turn the handle to accelera-
te, then release to stop the motor. When the engine shuts off your scooter will slow
automatically, use the brakes if necessary.
STOPPING & BRAKING
1. To make the scooter stop release the throttle and pull both brake levers carefully.
As soon as brake levers are pulled the engine of you scooter will automatically be
deactivated.
CHARGE INDICATOR, FAULT DIAGNOSIS
1. To brake, release the THROTTLE GRIP and depress the BRAKE LEVERS (on the
left/right side of the handlebars. Depressing the brake will disengage power to the
motor. When the unit feels like it is loosing power or not accelerating to full speed,
the scooter is ready to be re-charged.
NOTE: If the on/off switch is left in the ON position for more than 10-15 minutes
without moving, Smart Power will shut itself OFF. To reset, turn the unit OFF, wait a
few seconds and then switch it back ON again.

BRAKING SYSTEM

The scooter uses a pinch braking system for the front, and a disc/caliper system for
the rear They are both activated by a hand brake lever on the left and right side
of the handlebar. Squeezing the hand brake lever with your left hand activates
the rear brake. Squeezing the hand brake lever with your right hand activates
the front brake. Make sure to release the HAND THROTTLE GRIP when engaging
the brakes. Your scooter is equipped with switches on each brake lever that will
disengage power to the motor when the brake levers are depressed.
Practice braking on a smooth, dry surface to get used to the feel of the braking
system. Braking distance is affected by wet conditions and loose and uneven riding
surfaces.
8
instuctions sxt-scooters