Maintenance - Sirius Range Hoods SL-EM41 Instructions D'utilisation

MAINTENANCE

* An accurate maintenance guarantees good
functioning and long-lasting performance.
* Particular care is due to the grease filter
panel. It can be removed by pushing its spe-
cial handle toward the back-side of the coo-
ker hood and turning the filter downwards so
to unfasten it from its slot (Fig.3B-4A).
To insert the filter just perform the opposite
operation.
After 30 hours working (model SL-Modu-
le Luxury version), the push button control
panel will signal the saturation of the grease
filter by lighting all the buttons. In the SLTC
models (Touch Control Version) the grease
filter saturation is signalled by the flashing
of the two central push buttons (Fig. 21 C).
Press the timer button to reset
The grease filter needs cleaning by regular
hand-washing or in dishwashers every two
months at least or depending on its use.
* In case the appliance is used in its filtering
version, the active coal filter (Fig.16-20Z)
needs to be periodically replaced.
The coal filter can be removed by removing
the grease filter first (Fig.4A-16B), and by
pulling its special plastic tongue until it is un-
fastened from its slot. Re-insert the coal filter
by operating in the opposite way. The coal
filter needs replacing depending on the use,
but however every six months at least.
* To clean the appliance itself tepid water and
neutral detergent are recommended, whi-
le abrasive products should be avoided. For
steel appliances specialized detergents are
recommended (please follow the instructions
indicated o the product itself to obtain the
desired results).
* Before replacing the lamps, disconnect the
appliance from the electric mains. Remove
the grease filter and the carbon filter, if it is
inserted (Fig.11). Once the burnt out bulb is
localized, turn it anticlockwisely and replace
it with a bulb of the same type.
* To replace the halogen lamps, remove first
the glass-blocking ring (Fig.18A), by levering
with a screw-driver and thus removing the
opaque glass (Fig.18B) - when performing
this operation hold the opaque glass careful-
ly. Remove the lamp (Fig.18C) without tou-
ching it with uncovered hands. Replace it with
another lamp of the same kind. After the re-
placement, re-insert the glass-blocking ring
and fasten it.
To replace the dichroic lamp, remove the
lamp (Fig. 19) by inserting a screwdriver or
another sharp tool between the lamp and its
chrom support and replace it with a lamp of
the same kind.
* If the supply cord is damaged, it must be
replaced by the manufacturer or its sevice
agent or a similarly qualified person in order
to avoid a hazard.
.
16