Varta VSSP 2.0 Mode D'emploi page 76

Commissioning
You can operate the VSSP 2.0 via the display (1) that
is equipped with a touch screen.
Make the desired entries by tapping with the stylus (8)
on the displayed menu items or buttons. On the rear
of the device there is a receptacle (9) in which you can
store the stylus.
If you connect the VSSP 2.0 via the OBD plug
to the diagnostics interface of vehicle, or to a vehicle
battery via the alligator clamps, the device will be fed via
the vehicle battery. Via the four integrated rechargeable
batteries (15) the VSSP 2.0 can also be operated
independently.
The rechargeable batteries can be recharged via
the charger that you connect on the connection (5).
During the charging process the ON/OFF button
(2) on the VSSP 2.0 is illuminated red. If the device
is supplied via the rechargeable batteries the ON/OFF
button will be illuminated green.
You can replace the rechargeable batteries at the
end of their service life. To do this unscrew the Torx
screws (13), with which the cover (14) of the battery
compartment is fastened.
Under the rechargeable batteries there is a slot (16) for
an optional SD card that is not included in the scope
of delivery. If needed you can extend the memory
capacity of the VSSP 2.0 with this SD card.
Use of the service interface (6) is reserved for the
manufacturer's service organization.
14 VSSP 2.0