NTN-SNR AXC Série Mode D'emploi page 32

Setting the 1+2 "TIME" switch
A small screwdriver or the fingers may be used to set or adjust
the switches.
The operating time to emptying that has been set can be indicated
on the operating system, using the adhesive dots included. The
adhesive dots come in different colours and the operating time in months is printed on them.
Setting of 1+2 "TIME" switches of the quad switch for coding the four different operating times
Setting the 3+4 "VOL" switch
A small screwdriver or the fingers may be used to set or adjust the switches.
Where the position of the 3+4 "VOL" switch of the quad switch for coding does not
correspond to the size of the LC unit, this will result in a wrong signal being sent and in
over- or under-lubrication.
Setting of the 3+4 "VOL" switch of the quad switch for coding the two sizes of the LC unit
Switching on the lubricant dispenser
To switch on the lubricant dispenser, set the rotating switch on the cover of
the driving system (Fig. 16) from the "OFF" position to the "ON" position,
using a screwdriver. This will immediately start a dispensing process. To
switch off the lubricant dispenser, change the setting from "ON" to "OFF".
Fig.16
Changing the settings
The operating time and the size of the LC unit can only be adjusted when a new LC unit is being used.
Where the settings have been changed during operation and/or after commissioning, a new, fully filled LC
unit and a new set of batteries needs to be used.
If the settings are changed during operation, this will result in a fault in the controls and the electronic
monitoring system. Thus NTN-SNR cannot accept any liability for precise lubrication.
Each time the settings have been changed, use a new, fully filled LC unit and a new set of batteries.
Never use an LC unit that is already partially empty!
30