Keylock; Defrosting; Defrost Water - Gram Gastro 07 Mode D'emploi

Masquer les pouces Voir aussi pour Gastro 07:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32

Keylock

The keypad can be locked by keying the code: 123P (default setting).
that the keys are locked, and a short beep sounds. Now it is not possible to use the keys for
temperature setting etc.
The same code is to be used for unlocking the keypad again.
To change the code, see the Operation- and servicemanual.

Defrosting

Defrosting is automatically performed 4 times every 24 hours. If the cabinet is operating under
severe load (frequent door opening and frequent replenishment) manual defrosting can
become necessary. The cabinet can be manually defrosted by switching it off and on. It will
then start to defrost. The next defrost will occur 6 hours later.
defrosting cycle.
Do not use sharp or pointed objects to
accelerate the defrosting process.
The number of daily defrosts can be changed as follows:
• Press
P + 1
• Press
+
until dEF is shown on the display.
• Press
P
to display the current setting.
• Press
+
or
• Once the required value has been selected, press
• Press
twice to exit the menu.

Defrost water

Counters with compressor
Defrost water is led through a pipe, from the evaporator and into a tray behind the condenser.
Here, the water is evaporated by heat from the condenser.
Counters connected to a common compressor
The defrost water is led through a pipe to a tray behind the front panel, from where it is
evaporated by a heating element.
765041236
for more than 3 seconds.
-
to change the setting.
lights to indicate
lights up to indicate a
P
to confirm the new setting.
19

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Gastro 08

Table des Matières