Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Phillips screwdriver
■
1/4" (6.3 mm) nut driver
■
Measuring tape
■
Parts Needed
(2) Spacer bars - included with built-in microwave oven
■
(4) Hex-head washer screws - included with built-in
■
microwave oven
(4) Pan-head screws - included with built-in microwave oven
■
Parts Supplied
Bottom vent
■
2
06-May-2019 13:38:40 EDT | RELEASED
BUILT-IN MICROWAVE OVEN SAFETY
INSTALLATION REQUIREMENTS
Level
■
Drill
■
1/8" (3.1 mm) drill bit
■
In some European factories the letter "W" of the part code mentioned herein will be automatically
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Cabinet opening dimensions that are shown must be used.
■
Given dimensions provide minimum clearance with the
microwave oven.
Recessed installation area must provide complete enclosure
■
around the recessed portion of the microwave oven.
Microwave oven support surface must be solid, level and
■
flush with the bottom of the cabinet cutout. Floor must be
able to support a weight of 108 lbs (49 kg).
IMPORTANT: To avoid damage to your cabinets, check with your
builder or cabinet supplier to make sure that the materials used
will not discolor, delaminate or sustain other damage. This oven
has been designed in accordance with the requirements of UL
and CSA International and complies with the maximum allowable
wood cabinet temperatures of 194°F (90°C).
Bottom Vent Dimensions
A
27" (68.6 cm) Models
A. 26
⁄
" (67.9 cm) overall
3
4
width
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
30" (76.2 cm) Models
A. 29
⁄
" (75.6 cm) overall
3
4
width
Publicité
Table des Matières
