Zotac VR GO Guide De Démarrage Rapide page 3

QUICK START GUIDE
PAC K AG E C O N T E N T S
• 1 x ZOTAC VR GO SYSTEM
• 1 x Backpack Strap Add-on
• 1 x AC Adapter
• 1 x Power Cord
• 2 x Batteries
• 1 x Battery Charging Dock
• 1 x User Manual & Quick Start Guide
• 1 x Support DVD
• 1 x USB flash drive with OS drivers
• 1 x OS Recovery DVD (optional)
C U S TO M I Z I N G YO U R ZOTAC V R G O SYS T E M
1. Lay the ZOTAC VR GO SYSTEM on a flat surface with the
back cover facing upwards.
2. Locate the screws and remove.
3. Remove the cover off the ZOTAC VR GO SYSTEM.
I N S TA L L I N G H A R D D R I V E /S S D (O P T I O N A L )
1. Locate the 2.5-inch SATA hard drive/SSD slot and the
drive bracket. Remove the thumb screw and bracket.
2. Install the hard drive/SSD to the drive bracket.
3. Insert the bracket into the SATA slot.
4. Reinstall the thumb screw.
B AT T E RY C H A R G I N G
Note: The VR GO system does not support charging the batteries
directly.
1. Insert the batteries into the battery charging dock.
2. Connect the AC adapter to the battery charging dock.
3. All battery LEDs will be OFF when fully charged.
4. Press the battery status button to check battery status if need.
2
1
2
1
3 4
1
3
3
2
2
4