Start-Up; Operation - Beurer Shiatsu MG 295 Mode D'emploi

6. Start-up

CAUTION
• IMPORTANT: Before using the device for the first time, ensure you have released all transport
locks on the massage mechanism. To do this, remove the screws using the tool provided on
the rear of the seat cover. If the transport lock screws are not removed first and the Shiatsu
seat cover is used immediately, the device will become irreparably damaged and unusable.
The warranty will not apply in this instance.
• Reuse the transport lock screws when transporting the device in the future. Transporting the device
without using the transport locks could cause irreparable damage to the device.
• Position the seat cover upright on a suitable seat with a sitting area and backrest (chair, sofa or
similar). Make sure that the seat has a sufficiently high backrest.
• Use the flexible fastening straps and hook-and-loop fasteners to secure the Shiatsu seat cover.
• Connect the device to the mains by plugging the plug into the socket.

7. Operation

Gently press your back against the massage device to start with. Then make sure that you are in a comfort-
able position before gradually shifting your weight onto the massage device.The massage must be pleasant
and relaxing at all times. Stop the massage or change your position or the contact pressure if you find it is
painful or unpleasant.
• Do not force or jam any part of your body, in particular your fingers, between the moving massage elements
or their holders in the device.
• Sit comfortably and upright on the seat cover. Ensure you sit centered and such that the massage heads
can move to the left and right of your spinal column.
• Switch on the massager with the
The LEDs signal the massage functions which are currently selected.
• The automatic switch-off function is activated with selection of the massage region and is preset to 15 min-
utes. You can set the automatic switch-off function to 5, 10 or 15 minutes by pressing the timer button.
Please note that changing the timer setting makes the timer start to count again from the beginning. To
avoid overheating the device, select the maximum massage duration at the beginning of the massage and
do not change it again during the massage.
You can specify the settings as follows:
1. Demo run
Press the demo button to begin a quick 5-minute run-through of the functions contained in the device.
The manual controller indicates which function is being displayed by flashing the respective LED. The
device switches off automatically once the demo run has finished.
2. Shiatsu neck massage
Press the neck
massage direction. Press the
You can adjust the height of the neck massage by holding down one of the two arrows
neck button until the desired height is reached.
3. Shiatsu back massage
Press the 3D shiatsu button. Select the desired massage region with full back, upper back, lower back.
You can choose a spot massage i.e. a Shiatsu massage without vertical movement by pressing the spot
button. You can change the position of the spot massage by holding down one of the two arrows
next to the spot button until the desired position is reached.
Massage intensity
When using the Shiatsu Massage, two different massage speeds are available, which can be selected using
the speed button. If you have the rolling massage activated, first press the 3D shiatsu button in order to
change to Shiatsu Massage and then set the desired massage speed.
button.
button to start the neck massage. Press the
neck button again to switch off the neck massage.
neck
13
button again to change the
next to the