Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Use a heat-resistant cup for milk frothing. The cup can get very hot during
frothing.
•
Never turn the steam control button rapidly, as the steam will accumulate
rapidly in short time which may increase the potential of the risk of explosion.
•
Clean steam outlet with wet sponge immediately after steam stops
generating, but care not to hurt!
Make hot water
You can even use the Espresso machine to make tea or hot drinks. Make sure
that there is enough cold water.
1. Plug in power and then press the Expresso button
preheating
(If they are not lighted up, please tighten the steam knob clockwise).
2.
Swing the steam nozzle out and position a heat-resistant container under
the steam nozzle.
3. When preheating is done, the symbol
steady.
4. Turn on the steam knob carefully until the hot water comes out from the
steam tube.
5. All done, please turn off the steam knob and the machine will stop
working.
6. Switch off the power by pressing the Expresso
For Drip coffee
1. Make sure that there is enough water for making coffee.
2. Fill the coffee powder into the filter with the spoon, then install the funnel
for making drip coffee.
3. Note: fill the coffee powder into the filter with 2 spoons in max, and do not
use the fine powder.
4. Press the Drip Coffee button
machine begins to make coffee.
5. When coffee done, the warning tone will sound three times then the
machine will shut down automatically.
Instructions for use
will flash on display and other symbols will remains steady.
will
stop flashing and remain
, the
symbol lighted up, then the
English
. The symbol of
button.
7
Publicité
Table des Matières
