Deleting Remote Controls; Technical Data - Abus AZ4120 Instructions D'installation

7.4

Deleting remote controls

These components can not be deleted individually. To delete a
component, all radio remote controls and panic alarms must be
deleted.
1. Put the expansion module into learn mode.
2. Press the „SELECT" button until „
3. Press the „DELETE" button for approx. 4 seconds. A
double beep is emitted and all radio remote controls
and panic alarms are thereby deleted.
8. Operation
8.1 Displaying the signal strength
1. Put the expansion module into learn mode.
2. Press the „SELECT" button until the required zone
number or the radio remote control/panic alarm number
is displayed. Both LEDs on the PCB should now be off.
3. Activate the appropriate radio components. The green
LED (Pass) indicates that there is sufficient signal
strength. The red LED (Fail) indicates that there is in-
sufficient signal strength. The signal strength and zone
number are displayed alternately.
8.2 Jamming
Bridging the „Jamming" pin (radio interference)activates this
function. A jamming signal is a signal that transmits at the same
frequency as the radio component and that is strong enough to
displace the signal from the radio component for at least 30
seconds.
8.3 Supervision
Bridging the „Supervision" pin activates this function. The radio
expansion unit reports a detector as being faulty when it no
longer receives a signal from this detector for more than 2
hours.
8.4 Weak detector battery
If the battery power in the radio detector is weak then it reports
this to the radio expansion unit and this then passes on the
report to the alarm centre.

9. Technical data

Zones
8 wireless
zones
13
" is displayed.
Voltage supply 12 V DC