Abus AZ4120 Instructions D'installation page 12

To enter learn mode, simply open the tamper switch (remove
the front cover) and then press the „SELECT" button. The dis-
play now shows: "--". The module is now in learn mode.
NOTE:
You must leave the learn mode of the expansion module before
removing the power supply.
7.1 Teaching radio components
1. Put the expansion module into learn mode if you have
not already done so.
2. Make sure that the LED of the radio components to be
taught points to the learn sensor at a maximum dis-
tance of 100 mm.
3. Activate the radio components (when necessary by re-
leasing the tamper switch). The LED must thereby point
to the learn sensor of the expansion module.
The expansion module emits a double beep when the
radio component has been successfully taught. Detec-
tors that have been taught now show the signal
strength on the left (max. 9) and the channel number on
the right. The channel is assigned automatically.
A taught panic alarm or remote control shows the num-
ber of learnt components by displaying„
to the signal strength.
If the radio component can not be taught then the ex-
pansion module emits a single beep.
4. Repeat steps 2 and 3 to teach additional radio compo-
nents. Please observe that a maximum of 6 radio re-
mote controls or panic alarms can be taught.
7.2 Assigning detectors to particular zones
1. Put the expansion module into learn mode.
2. Press the „SELECT" button until the required zone is
displayed. If the display flashes then the zone is not as-
signed (free). If the display is constant then the zone is
assigned.
3. Now carry out steps 2 and 3 as described in „Teaching
radio components".
7.3 Deleting detectors
1. Put the expansion module into learn mode.
2. Press the „SELECT" button until the required zone is
displayed.
3. Press the „DELETE" button for approx. 4 seconds. A
double beep is emitted and the detector is deleted.
12
„ alternately