Turn On The Device - Nyne Home Audio Série Manuel Utilisateur

To replace the remote control battery:
1
Remove the battery cover.
2
Replace the old battery with a
new one (type: CR2025) with the
correct polarity.
3
Mount the battery cover securely.

Turn on the device

1
Turn the
back of the device to the
position.
☞
The power/status indicator on the
front of the device lights up red.
2
Press on the remote control
(or tap on the top panel).
☞
The indicator of the last selected
audio source lights up.
☞
The volume indicator bars on the
volume touchpad light up.
NYNE NH-5000_User Manual_A5.indb 13 NYNE NH-5000_User Manual_A5.indb 13
switch on the
☞
The power/status indicator fl ashes
red and blue alternately for a short
while, and then stays blue.
Tip:
•
If the device switches on to the
Bluetooth source, the power/status
indicator fl ashes blue when no
Bluetooth connection has been
set up.
To switch the device to standby mode:
• Press on the remote control
(or tap on the top panel) again.
EN 13
5/24/2012 10:16:58 AM 5/24/2012 10:16:58 AM