Complete The Assembly; Workbench Care - Gladiator Garageworks GAWB66BAWG Instructions D'assemblage

4. Using two lag screws per brace, fasten the angle braces to the
underside of the workbench top. Do not completely tighten the
screws.
5. Using three Allen head bolts per brace, fasten the angle braces
to the legs.
A. Allen head bolts
B. Lag screws
6. Completely tighten all screws and bolts.
7. Screw in the leveling feet. The leveling feet have a flat side
designed for use with an adjustable wrench, if needed.
IMPORTANT: Screw a leveling foot far enough into each leg so
that it is at least ¹⁄₄" (0.635 cm) or a minimum of five full turns into
the leg.
4

Complete the Assembly

WARNING
Excessive Weight Hazard
Use two or more people to move and assemble
workbench.
Failure to do so can result in back or other injury.
1. Using two or more people, stand the workbench upright and
place it in its final location.
2. Adjust the leveling feet as needed.
IMPORTANT: When adjusting the leveling feet, make sure they
are at least ¹⁄₄" (0.635 cm) deep into the workbench leg.

Workbench Care

1. Wash the workbench with a mild detergent and warm water. Do
not allow water to remain on the workbench for any length of
time.
2. Rinse completely and dry thoroughly.