Accessories; Operating Elements; Functional Description; Motion Detector - BASETech 75 18 18 Notice D'emploi

On commercial premises, the relevant accident prevention regulations of the relevant professional insurance
association for electrical systems and operating materials must be complied with.
Accessories (included with alarm set)
- Passive infrared (PIR) alarm system
- Infrared (IR) remote control (2 pieces)
- 12 V DC mains adaptor (230 V 50 Hz / 12 V DC 500 mA)
- Magnetic contacts (5 pairs)
- Piezo siren
- 30 m cable (2 x 15 m cable)

Operating elements

Illustration - foldout page
1 Motion sensor
2 Yellow LED for home mode
3 Green LED for away mode
4 Red LED for walk test / status display
5 Infrared receiver
6 Battery compartment and connection terminal
7 Built-in siren
8 Mounting holes
9 Cable feedthroughs
10 Coding bar
11 Jumper
12 Connection terminals
13 9 volt battery clip

Functional description

Motion detector

The motion sensor detects motion within its detection area so that you can monitor the entrance, for example,
to a house, a garage, garden, or cellar. The alarm is activated if a person enters the detection area.
The motion detector responds to heat radiation (infrared radiation) of moving objects that enter the sensor's
detection range, e.g. persons and animals. The angle of detection is 110°. The IR range is approximately 12 m.
The sensor must „see" the area it is to keep under surveillance. Heat radiation travels in straight lines but is
stopped, for example, by glass or other fixed objects. Keep this and other sources of interference in mind
before mounting the device.
We recommend occasional cleaning with a soft dry cloth. Detergents must not be used.
19