Hands-Free Function - Hama POCKET Mode D'emploi

Note – Connection impaired
After the speaker and terminal device have
been paired, a connection is established
automatically. If the Bluetooth connection
is not established automatically, check
the following:
• Check the Bluetooth settings of your
terminal device to see whether Hama
Speaker is connected. If not, repeat the
steps listed under Bluetooth pairing.
• Check whether your terminal device
and the speaker are less than 10
metres apart. If not, move them closer
together.
• Check whether obstacles are impairing
the range. If so, move the devices
closer together.
• Check whether the audio cable is
connected to the speaker. If so,
disconnect it.
4.4 Automatic Bluetooth connection
(after successful pairing)
• Make sure that your Bluetooth-capable
terminal device is on and Bluetooth is
activated.
• Make sure that your Bluetooth-capable
terminal device is visible for other Bluetooth
devices.
• Make sure that the speaker is located within
the Bluetooth range of max. 10 metres.
• Switch on the speaker (1). The device
will emit a sound and the status LED will
ash, con rming that the device is ready
for operation.
• After successful connection, the LED
indicator will ash.
• Start and stop audio playback on your
terminal device or using Play/Pause (2) on
the speaker.

4.5 Hands-free function

You can use the speaker as a hands-free set
for your mobile phone. For this function,
the mobile phone must be connected to the
speaker via Bluetooth.
• Make sure that your mobile phone is
connected to the Bluetooth speaker.
• If you receive a call on your mobile phone,
an announcement of the telephone number
will play.
• Press Call (5) to accept the call.
• Press Call (5) again to end the call.
Note – Call quality
To increase the call quality, make sure that
you are near the speaker with your mobile
phone during the call.
5