Rami CSS 204 Manuel Utilisateur page 17

FRONT PANEL
INPUTS INPUTS
SAVE LEVEL SAVE LEVEL MASTER MASTER
L L R R
+ + + +
B B
A A
14 - Return time setting. Time before return to normal state after default disappeared wathever was
the Alarm type. Use of dip switches, on in lower position from 3 to 38 seconds.
Each dip switch as its own time value (20-10-5-3 s)
Note: If all switches are off, the CCS 204 will return immediately to normal state after a missing
signal alarm.
15 - Switch to inforce alarm . This switch allows :
to check the start of external machines using the remote controls.
to keep the alarm state during repair of faulty signal source.
Attention: Using the switch, the delay settings do not aplly.
16 - Light display for alarm.
Blinking: automatic alarm caused by audio signal default.
Continuous: the switch 15 is on permanent.
17 - Bar graph Peakmeter.
Displays the output level.
Note : displayed levels are relative. The 0dB reference is set using internal dip switches to
+12 or +6 dBu (peak level).
Factory setting is +6dBu.
18 - ¼" stereo headphone connector.
Rami - CSS 204
BLANK DETECTION BLANK DETECTION
THRESHOLD THRESHOLD ALARM DELAY ALARM DELAY
(-dBu) (-dBu) (S) (S)
DETECTION DETECTION MODE MODE
10 10 2 2 20 20 5 5 1 1 1 1
20 20 5 5 30 10 30 10 2 2 1 1
BLANK BLANK
ON ON L L L or R L or R
1 2 3 4 1 2 3 4 1 1 2 2 3 3 4 5 6 7 8 4 5 6 7 8
R R L L and and R R
OFF OFF
on on on on
- - + +
PLAY PLAY
VOLUME VOLUME
SD CARD SD CARD
17
ALARM ALARM
CSS 204 CSS 204
ANALOG WATCHDOG WITH BACK UP ANALOG WATCHDOG WITH BACK UP
RESET RESET Fixed Fixed TEST TEST
DELAY DELAY Flashing Flashing ALARM ALARM
(S) (S) OUT CONTROL OUT CONTROL
10 10 3 3
TEST TEST
20 20 5 5
-dB -dB
SURVEY SURVEY PEAKMETER PEAKMETER
1 2 3 4 1 2 3 4
on on
-15 -15 -12 -12 -9 -9 -6 -6 -3 -3 O O +3 +3
CONTROL CONTROL
+12 dBu +12 dBu
OFF OFF OFF OFF
+6 dBu +6 dBu
1 2 3 4 1 2 3 4
next
+dB +dB
LEFT LEFT
RIGHT RIGHT
+6 +6 +9 +9 +12 +12 PHONES PHONES
OFF OFF OFF OFF
ENGLISH