ESX SIGNUM SL300A Mode D'emploi page 6

Please read the user's manual carefully before the installation and the first operation
of the amplifier.
SPECIFICATIONS
Subwoofer
Output Power RMS
Output Power Max
Lowpass Filter
Highpass Filter for Loudspeaker Outputs
Subsonic Filter
Phase Shift
Operating Voltage
Fuse Rating
Dimensions (B x H x L)
All Specifications are subject to change
IMPORTANT NOTES PRIOR TO INSTALLATION
• This device is only suited for a 12 volt system with negative ground.
• Ensure that the input and output cables are sufficiently separated from the power supply cables. Otherwise
interferences may occur.
• Ensure the accessibility of the fuse and the operating elements after installation.
• The reliability and performance of the amplifier depends on the quality of installation. Preferably consult an
expert to install the system.
• Avoid any damage or removing of the components of the vehicle like wires, cables, board computer, seat
belts, gas tank or the like.
6
SL300A
13 cm (5.25")
1 x 100 W for Subwoofer
2 x 35 W for additional Loudspeakers
1 x 200 W for Subwoofer
2 x 50 W for additional Loudspeakers
50 – 150 Hz
100 / 300 Hz
Fixed at 25 Hz
0° / 180°
+12 V (9 – 15 V), negative ground
20 A
Ø 374 x 105 mm