Troubleshooting; Technical Data - DS Produkte Z 02191 Mode D'emploi

3. Take the lid and the plunger off.
4. Remove the juicer sieve from the drive disc of the motor unit. To do so, pull it up and
off carefully using both hands.
Notice: When using the device for the fi rst time, the juicer sieve fi ts very tight on the
drive disc. For this reason, be particularly careful when removing it to prevent injury!
5. Remove the pomace container with the juice discharge.
6. Empty the pomace container and clean all removable parts with warm water and a
mild detergent or in the dishwasher. Then dry all parts thoroughly. Please keep in
mind: All removable parts may be cleaned in the dish washer. However, frequent
cleaning in the dishwasher may dull the blades of the juicer sieve. For this reason we
recommend cleaning by hand.
7. If necessary, clean the motor unit with a damp cloth.
8. Assemble the device once all parts have dried completely.
9. Store the device in a clean, dry, frost-free location that is not accessible to children
and animals.

Troubleshooting

If the device is not working properly, please check whether you are able to rectify the
problem yourself fi rst.
Do not attempt to repair a defective device yourself!
Problem
The device is not
working.

Technical data

Product number:
Model number:
Voltage supply:
Output:
Safety class:
Suitable for use with food.
19
Potential cause/solution
• Is the mains plug properly connected with the socket?
• Is the socket defective? Try another socket.
• Check the fuse for your mains connection.
• Is the device correctly assembled? Check if the juicer
sieve is correctly seated and if the locking clips have been
closed.
• Is the device activated? Press the On/Off switch.
Z 02191
XJ-14416
220 – 240 V~, 50 Hz
1000 W
II
Customer service/
importer:
DS Produkte GmbH
Am Heisterbusch 1
19258 Gallin
Germany
Tel.: +49 38851 314650
*) Calls subject to a charge.
GB