AEG KD91405M Mode D'emploi page 7

WARNING
!
Repairs undertaken during the
guarantee period must only be done
by technicians authorised by the
manufacturer. If this is not the case
then any damage resulting from the
repair in question is excluded from the
guarantee.
WARNING
!
The appliance must be disconnected
from the electrical current when
installation and repair work is being
done. To disconnect the appliance
from the current, one of the following
conditions must apply:
The switchboard fuses / circuit
breakers must be disconnected.
The plug should be removed from the
socket. To remove the plug from the
socket do not pull on the electric cable
but rather pull out the plug itself
directly.
INSTALLATION
The Warming Drawer should only be
built-in in combination with those
appliances indicated by the
manufacturer. If it is fitted in
combination with other appliances, the
guarantee is no longer valid since it is
impossible to guarantee that the
Warming Drawer will work correctly.
To build-in the Warming Drawer in
combination with another appliance
there must be a fixed, interim shelf in
the housing unit to support the weight
of both appliances.
The appliance to be combined with the
Warming Drawer will be placed directly
on the latter without any need to have
a separating shelf.
To build-in the appliance which is
combined with the Warming Drawer,
follow the instructions set out in the
respective instructions and fitting
booklet.
The relevant installation dimensions
are indicated in mm in the diagrams
shown at the end of this booklet.
Proceed as follows:
1. Place the Warming Drawer on the
shelf and slide it towards the
interior of the niche in such a way
that it is centred and completely
lined up with the front of the unit.
2. Check that the Warming Drawer's
frame is properly levelled and is
sitting evenly on the shelf.
3. Open the drawer and fix the
Warming Drawer to the sides of the
unit using the provided screws.
www.aeg.com 6