Asept-Air LIFE CELL 1550 UV Manuel Du Propriétaire page 6

2. The indicated lamp is burned out and needs to be replaced. A burnt-out lamp is usually identified by
the presence of a thick and opaque black ring around the inside of the glass tube on either or both ends
just before the ceramic end caps, as shown in the diagrams below. Replacement is described in
sections 8.4.4 and 8.5.1. We suggest UV lamps always be replaced in pairs.
NEW UV LAMP
Stand-By Indicator – Illuminates when unit is connected to a live power source but not operating.
5.6.
Shut-Off Timer Indicator – Displays the number of hours your air purifier will operate before shutting off.
5.7.
Purify Air Feature Indicator – Illuminates when PURIFY AIR feature is activated.
5.8.
6. OPERATION
POWER Button (K) - The power button is used to turn the unit on or off. The illuminated ring around its outside
6.1.
edge indicates the fan speed with green = quiet, blue = low, orange = medium and red = high.
FUNCTION Buttons (L)
6.2.
6.2.1 FAN SPEED Button
When in MANUAL Mode, the FAN SPEED button is used to cycle through the fan speeds to select the
one that suits your needs. Pressing it when the unit is in AUTO Mode, switches the unit to MANUAL
Mode.
6.2.2 TIMER Button
Once your air purifier is running, pressing the TIMER button will activate the TIMER MODE. You then
set the timer according to your needs.
6.2.3 AUTO Button
Turns the AUTO Mode on and off. When the AUTO Mode is activated, the AUTO indicator illuminates
in the LED Display. When AUTO indicator is not lit, the unit is in MANUAL Mode.
6.2.4 PURIFY AIR Button
Turns the PURIFY AIR feature (UV lamps and PCO Chamber on and off when the unit is in MANUAL
Mode. It is disabled when the unit is in AUTO mode.
REMOTE CONTROL (O)
6.3.
6.3.1 Remote Operation
Your Life Cell 1550 UV air purifier comes with an line-of-sight Infrared remote control that permits
operating the unit from a distance of up to 30'/9m away. To use the remote simply point it directly at
the front panel of your unit. The remote must have a direct view of your unit's front panel to function
properly.
6.3.2 Buttons Description
On/Off: Turns the unit on or off.
Fan Speed: Adjusts the fan speed.
Timer+: Increases the timer in 1 hour increments.
Timer-: Decreases the timer in 1 hour increments.
Auto: Turns the Auto Mode on or off.
Purify Air: Turns the Purify Air Mode on or off.
USED BUT WORKING LAMP
6
BURNED OUT UV LAMP