Waypoint Mode Setup - Navibe MERCURY 100 Guide Utilisateur

Blinking items include: MI or KM, mi/h or km/h. If MI is blinking then mi/h will be blinking as
well. If KM is blinking then km/h will be blinking. Pressing the "Reset/Mark" button (i.e.
"Start/Stop" button) switches between metric or imperial units and they will continue to blink.
If the unit of measurement is switched to imperial or metric, other functions' unit of
measurement will switch as well.
Pressing the "Select" button for a third time reverts back to the first blinking item.
Under any display mode, holding down "Select" for 3 seconds closes Setup mode and the
display then reverts back to user mode.

6.6.2 Waypoint Mode Setup:

In Waypoint modes A~D, hold down the "Select" button for 3 seconds opens the
The current waypoint will also start blinking. For example, if currently set to Waypoint B, B
will flash during Setup mode. The blinking items include DTG
Pressing the "Reset/Mark" button (i.e. "Start/Stop" button) resets the waypoint and marks
the current coordinates. The calculated DTG should be 0.00. Once reset it will continue
blinking.
1. Pressing the "Select" button for the second time
Blinking items include: MI or KM, mi/h or km/h. If MI is blinking then mi/h will be blinking as
well. If KM is blinking then km/h will be blinking. Pressing the "Reset/Mark" button (i.e.
"Start/Stop" button) switches between metric or imperial units and they will continue to blink.
If the unit of measurement is switched to imperial or metric, other functions' unit of
measurement will switch as well.
2. Pressing the "Select" button for a third time reverts back to the first blinking item.
Under any display mode, holding down "Select" for 3 seconds closes Setup mode and the
display then reverts back to user mode.
40
display.
distance reading.