Bike Mode Setup - Navibe MERCURY 100 Guide Utilisateur

6.6 Setup Mode:
In Bike mode, Waypoint
"Select" button for 3 seconds switches to Setup Mode.
Bike Mode: Time, DTG, MAX and AVG, Kcal, ODO Reset, Cycle Unit.
Waypoint Mode: Reset Waypoints A, B, C, D (Mark Waypoint), Cycle Unit.
Route Mode: Reset Destinations 01~99 (Mark Waypoint), Cycle Unit.

6.6.1 Bike Mode Setup:

Holding down the "Select" button for 3 seconds in this user mode opens the
Blinking items include:
In Setup Mode, pressing the "Reset/Mark" button (i.e. "Start/Stop" button) resets everything
to 0. The 4-digit display is set to 0.00 and 3-digit display is set to 0.0 as well while
continuing to blink. The items reset include:
(1) Time, Distance.
(2) Maximum and Average Speed.
(3) Calories.
4. Pressing the "Select" button for the first time
Blinking items include: ODO and
"Reset/Mark" button (i.e. "Start/Stop" button) resets the odometer. After reset it continues to
blink and display the number 0.00.
5. Pressing the "Select" button for the second time
, Time,
distance display, MAX, AVG,
mode or Route
time display, DST,
distance display. Pressing the
39
mode, holding down the
display.
speed display, Kcal.