Assembling The Stand; Assembly Procedure - Pioneer PDK-TS05 Mode D'emploi

Assembling the Stand

Note
Always assemble it on a flat table etc.
Insert the screws in the holes vertically and do not tighten
them with more force than necessary.

Assembly Procedure

1
Select the support columns to attach.
Select the support columns according to the settings of
the speakers that you have purchased with reference to
the following stipulation (Only one type of the two types
of available support columns should be used).
When the speakers you have purchased are PDP-
S25-LR or PDP-S26-LR.
[Support column used: support column S (short
columns)]
Support column used:
support column S
When the speakers you have purchased are PDP-
S21-LR or PDP-S22-LR.
When installing speakers on both sides of the
plasma display [Support column used: support
column S (short columns)]
Support column used:
support column S
16
En
When installing speakers at the bottom of the
plasma display [Support column used: support
column L (long columns)]
Note
The PDP-S25-LR and PDP-S26-LR cannot be installed at
the bottom of the plasma display.
Support column used:
support column L
2
Secure the support column to the stand
with the Installation screws 1 (4
locations on the left and right).
Using the enclosed hexagonal wrench, first loosely
attach the top attachment screw, then loosely attach
the bottom attachment screw.
Installation screws
(M8 x 16 mm: silver)
3
Fully tighten the Installation screws (4
locations on the left and right).
Fully tighten the attachment screws.
1