Hazards Caused By Non-Observation Of Safety Instructions; Safety-Conscious Work; Safety Instructions For User / Operator; Safety Instructions For Maintenance, Inspection And Installation Work - evenes 93-182-02-dbl-01 Série Mode D'emploi

the pump operator. Moreover, the operator has to ensure that the content of the operating
instructions is understood completely by the staff.
This device is not intended for use by individuals (including children) with reduced physical, sensory,
or mental capabilities. It may also not be used by individuals who lack experience and/or knowledge
unless they are supervised by a person responsible for their safety or have received instructions on
how to use the device from any such authorized person.
Children should be supervised to ensure that they do not play with the device.

2.3 Hazards caused by non-observation of safety instructions

The non-observation of the safety instructions may endanger persons as well as the environment, and
may have consequences for the environment and the pump. The non-observation of the safety
instructions will result in the loss of all claims for damages.
In detail, the non-observation may cause the following hazards, for example:
- Malfunction of important functions of the pump
- Malfunction of the mandatory methods of maintenance and repair
- Danger to persons caused by electrical, mechanical and chemical effects
- Danger to the environment caused by leakage of dangerous substances

2.4 Safety-conscious work

The safety instructions mentioned in these operating instructions, the existing national regulations on
accident prevention as well as potential in-company work, operating and safety instructions of the user
must be observed.

2.5 Safety instructions for user / operator

- If hot or cold device parts could lead to hazards, these parts have to be protected
against touch by the user.
- The pumps are equipped with a thermal winding protection, so when the motor
cools down, the pump will start automatically. In case of repairs and maintenance
works, the device must therefore definitely disconnected from the mains!
- Touch protection for moving parts (such as coupling) must not be removed from
plants in operation.
- Leakage (of the shaft seal, for example) of hazardous material conveyed (e.g.
explosive, toxic, hot) must be removed in such a way that no danger is caused to
persons and the environment. Legal regulations have to be observed.
- Hazards caused by electric energy must be excluded (for details here, please refer
to the country-specific regulations and the regulations of the local energy supply
companies).

2.6 Safety instructions for maintenance, inspection and installation work

The user has to make sure that all maintenance, inspection and installation work is carried out by
authorised and qualified specialist personnel only, who has sufficiently been informed by studying the
operating instructions.
Only genuine spare parts may be used.
Basically, work on the pump may be carried out only at standstill. The procedure to shut down the
pump described in the operating instructions must be observed by all means.
Pumps or pump assemblies, which convey media hazardous to health, must be decontaminated.
Immediately after completing the work, all safety and protection devices have to be fitted again and/or
have to be made functional again.
Before restart, the points listed in the chapter on initial commissioning have to be observed.

2.7 Unauthorised modification and spare parts production

Modifications or changes to the machine shall be permissible only after consultation with the
manufacturer. Original spare parts and accessories authorised by the manufacturer serve to ensure
safety. The use of other parts may results in the loss of liability for the consequences that may occur.
16
E