Sharp PN-L851H Manuel D'installation page 12

nOperations after first power-on
Set POWER SAVE MODE
When the monitor is turned on for the first time after being
shipped from the factory, the power save mode setting screen
will be displayed. Set it to YES or NO.
YES ..... POWER SAVE MODE is set to ON. Current
consumption is reduced while the monitor is in
standby mode. Android is also shut down. Note,
however, that the startup time from standby mode
becomes longer.
NO ....... POWER SAVE MODE is set to OFF. Startup time
from standby mode is reduced. Note, however, that
more power will be consumed in standby mode.
Android continues to run in standby mode.
Even after being set, you can change the POWER SAVE
MODE. (See OPERATION MANUAL.)
Set the date/time
The date/time setting screen appears.
DATE/TIME SETTING
- - / - - / - - - - - - - - : - - : - - - -
The date/time setting must be set by APPLICATION.
[SET] : Display "Date & time" on APPLICATION
SET
OK:[ENTER] END:[RETURN]
1. Select "SET".
The input mode changes to APPLICATION, and the "Date
& time" screen appears.
2. Select "Set date".
3. Set the date and select "OK".
The "Date & time" screen appears.
4. Select "Set time".
5. Set the time and select "OK".
The "Date & time" screen appears.
8
E
CANCEL
6. Press the RETURN button on the remote control unit.
This is the home screen when the input mode is
APPLICATION.
For information on APPLICATION mode, see the Software
Guide.
• Be sure to set the date and time.
TIPS
• The clock is maintained by the internal battery.
• If you already set the time but the date/time setting screen
appears when the power is turned on, the internal battery
may be exhausted. After replacing the internal battery, set
the date and time.
• Please contact an authorized SHARP servicing dealer
or service center for assistance with internal battery
replacement.
• Estimated service life of the internal battery: About 5 years
(depending on monitor operation)
• The initial battery was inserted at the factory when the
monitor was shipped, so it may run out of power before its
expected operation life.