Toshiba ESTIA HWS-802XWHM3-E Manuel D'installation page 13

Hydro Unit
The Hydro Unit can be installed directly without using the fixing angles.
However, the back side of the Hydro Unit can be highly heated, therefore, the installing surface must be heat-
resistant.
▼ Fig. 7-05
Remove the M5a screws to
detach the fixing angles.
Install the Hydro Unit so that its tilting angle falls within the range below.
▼ Fig. 7-08
▼ Fig. 7-06
380
± 1°
– 13 –
▼ Fig. 7-07
Secure the Hydro Unit with
plain washers and nuts.
▼ Fig. 7-09
± 1°
Installation Manual
M10
M10
EN
12-EN