Operating Instructions; Clik-Tite Connectors - Stryker TP600 Manuel D'utilisation

CLIK-TITE CONNECTORS

The TP600 & 700 Series T/Pump is supplied with Clik-Tite
To connect and disconnect Clik-Tite
1. Insert male fittings into female fittings with a twisting motion
(Figures 5A and 5B).
2. When fittings are fully inserted, snap locking ring into place
(Figures 5C and 5D).
3. To disconnect, reverse the procedure.
4. To open or close the hose pinch clamps:
• Open the clamp by pushing the serrated end (Figure 6B).
• Close the clamp by pressing the clamp together (Figure 6C).
Note: Refer to Figure 1B on page 1-5
5A
5C
6B

Operating Instructions

® connectors.
® connectors from hose to pad:
when connecting multiple pads.
5B
5D
6C
Figure 5: Clik-Tite ® Connectors
101515 REV C 1-11