Rinse Aid - KENMORE ELITE ULTRACLEAN 665.1279 Guide D'utilisation

Powders and Gels
Water Soil
Hardness Level
Light
Soft
(0-4 grains
Normal
per U.S.
gallon) Heavy
Medium Light
(5-9 grains
Normal
per U.S.
gallon)
Heavy
Hard Light
(10-14 grains
Normal
per U.S.
gallon)
Heavy
*Full pre-wash compartment contains 7 tsp (35 mL), and full
main wash cup contains 9 tsp (45 mL).
IMPORTANT: Extremely hard water mineral deposits (15 grains
per U.S. gallon or more) can cause damage to your dishwasher
and make it difficult to achieve good results. A water softener is
recommended to avoid damage and achieve good results. You
may bring your water samples to Sears to check hardness level.

Rinse Aid

IMPORTANT: Your dishwasher is designed to use a liquid rinse
aid. The use of rinse aids greatly improves drying by allowing
water to drain from the dishes after the final rinse. They also
keep water from forming droplets that can dry as spots or
streaks.
12
Pre-Wash Main Wash
Compartment Compartment
¹⁄₂
None
¹⁄₂
None
¹⁄₂
Full
¹⁄₂
None
¹⁄₂ ¹⁄₂
Full* Full*
¹⁄₂
Full*
Full* Full*
Full* Full*
Filling the dispenser
The dispenser holds 5 oz (150 mL) of rinse aid. Under most
conditions this will last 1 to 3 months.
1. Turn the knob to the REFILL position and remove.
2. Pour rinse aid into the opening until the indicator points to
FULL. Do not overfill.
3. Clean up any spilled rinse aid. Spilled rinse aid can create
excessive suds.
4. Replace the knob and turn to the LOCK position.
NOTE: Indicator reads correct fill level when door is completely
opened.
Rinse Aid Setting
Your rinse aid dispenser is adjustable. For most water conditions,
the factory setting will give good results. If you have hard water
and notice calcium buildup on your dishware, you may want to
try a higher setting. If you notice foam in your dishwasher, use a
lower setting.
To adjust the setting
1. Turn the knob to the REFILL position and remove.
2. Turn the arrow inside the dispenser to the desired setting.
3. Replace the knob and turn to the LOCK position.