TFA KlimaLogg Pro Mode D'emploi page 38

This setting is related to the alarm sound only. Alarms that have been
set, continue to be registered. Also they are shown on the display as
well. Only the sound is activated or inactivated by this setting in case of
Time reception ON/OFF:
„DCF" appears on the text display and the default „On" starts
flashing.
With the + or - button you can deactivate (OFF) or activate (On)
the DCF time reception.
12/24-Hour format:
„TIMEFORMAT" appears on the text display and the default „24 h"
starts flashing. Also the current time will be shown in the display.
With the + or - button you can select between 12 hr or 24 hr time
format. If you select the 12 hr time format, AM or PM appears in
the display additionally.
Temperature unit (°C/ °F):
„TEMP UNIT" appears on the text display and the default „°C"
starts flashing. With the + or - button you can select between „°C"
or „°F" as the temperature unit.
Manual time setting:
„TIME SET" appears on the text display and the hour digits start
flashing. With the + or - button you can set the hours.
Press SET button again and set the minutes by the same way.
Manual date setting:
„DATE SET" appears on the text display and the year starts
flashing. With the + or - button you can set the year.
Press SET button again and the month starts flashing. With the +
or - button you can set the month.
Press SET button again and the day starts flashing. With the + or -
button you can set the day.
Main reset (resetting back to factory settings):
"MAIN RESET" appears on the text display. If the "OK/MAX.MIN."
button is now pressed and held for three seconds, the KlimaLogg
Pro deletes all settings and recorded data. The KlimaLogg Pro is
reset to factory settings. After the "OK/MAX.MIN." button has been
Note:
an alarm.
37