Part Names And Functions; Browser Section; Deck Section - PIONEER DJ DJM-S9 Mode D'emploi

Part names and functions

For further details on each unit, refer to the Operating Instructions and
the Serato DJ software manual.
For instructions on obtaining the Operating Instructions and the
Serato DJ software manual, see Acquiring the manual on page 5 .
1
2
4
2

1 Browser section

2 Deck section

3 Mixer section
4 Effect section
Browser section
1
2
1 Rotary selector
Turn:
The cursor moves vertically.
Press:
The next level is displayed.
2 BACK button
The cursor moves to the previous level.
[SHIFT] + press:
Switches the Serato DJ layout.
3 LOAD button
The selected tracks are loaded to the respective decks.
[SHIFT] + press:
Loads tracks to the [Prepare] panel.
8
En
3 1
2
3
3
Deck section
1
2 3
4
1 4BEAT LOOP button
Turns the auto 4-beat loop on.
[SHIFT] + press:
Switches looping between active and non-active. (Loop Active)
2 LOOP 1/2X button
Halves the loop playback length.
[SHIFT] + press:
Sets a loop in point.
3 LOOP 2X button
Doubles the loop playback length.
[SHIFT] + press:
Sets a loop out point and starts loop playback.
4 PARAMETER button, PARAMETER button
Sets a parameter for the loop roll, slicer, sampler and other
functions.
[SHIFT] + press:
Sets the second parameters such as the loop roll, slicer, sampler,
etc.
5 Performance pads
Control the hot cue, loop roll, slicer, sampler and other functions.
6 PAD section display
Displays the currently set PAD mode and parameters, etc.
7 ROLL mode button
Sets the roll mode.
[SHIFT] + press:
Sets the saved loop mode.
8 SAMPLER mode button
Sets the sampler mode.
[SHIFT] + press:
Sets the sampler roll mode.
5
6
7
8
9 a