Certificate Of Warranty - Rona 2001516 Manuel D'utilisation

OPERATING INSTRUCTIONS
All drilling operations
3) Mark off the centre of the hole using a
centre punch or nail.
4) Don't force the drill, let it work at its
own pace
5) Keep the drill bit sharp.
6) Reduce pressure, as the drill is about to
break through the item being drilled.
Chuck replacement
Chuck removal
Always wear eye protection.
Turn the torque adjustment collar selection
collar (8) to the "drill" position and low gear, on
the gear selector (6). Tighten the chuck around
the shorter end of a hex key (not supplied) of
5mm or greater size. Using a wooden mallet
or similar object, strike the longer end in the
clockwise direction. This will loosen the screw
inside the chuck.
1) Open chuck jaws fully.
2) Insert a 5mm hex key into front of chuck
between jaws to engage screw head.
Remove screw by turning clockwise.
3) Place the hex key in chuck and tighten.
Using a wooden mallet or similar object,
strike key sharply in the anti-clockwise
direction. This will loosen the chuck so that
it can be unscrewed by hand.
Chuck installation
1) Screw the chuck on by hand as far as it will
GB
go and insert screw (LH thread).
2) Tighten the chuck around the shorter end of
hex key (not supplied) strike the longer end
in the clockwise direction with a wooden
mallet.
22
3) Remove the hex key and open the jaws
fully. Tighten the screw in the centre of the
chuck firmly, with the hex key in an anti-
clockwise direction.
Maintenance
1) Store the tool, instruction manual and
accessories in a secure place. In this way
you will always have all the information and
parts on hand.
2) Keep the tool's air vents unclogged and
clean at all times.
3) Remove dust and dirt regularly. Cleaning
is best done with compressed air or a rag.
4) Never use caustic agents to clean
plastic parts.
5) Lubricate the guide roller from time to time
with a drop of oil. It will extend the life of
the roller.
CAUTION. Do not use cleaning agents to
clean the plastic parts of the tool. A mild
detergent on a damp cloth is recommended.
Water must never come into contact with
the tool.
General inspection
Regularly check that all the fixing
screws are tight. They may vibrate
loose over time.

CERTIFICATE OF WARRANTY

Guarantee
Thank you for investing in a Rona power
tool. These products have been made to
demanding, high quality standards and
are guaranteed for domestic use against
manufacturing faults for a period of 36
months from the date of purchase.
This guarantee does not affect your
statutory rights. In case of any malfunction of
your RONA tool (failure, missing part, etc.),
please contact one of our service technician
at our toll free service line at 1-888-874-8661
from 9 am to 9 pm, Monday to Friday,
Eastern time.
Normal wear and tear, including accessory
wear, is not covered under guarantee. The
product is guaranteed for 36 months if used
for normal trade purposes. Any guarantee is
invalid if the product has been overloaded
or subject to neglect, improper use or an
attempted repair other than by an authorised
agent. Heavy duty, daily professional or hire
usage are not guaranteed. Due to continuous
product improvement, we reserve the right
to change the product specification without
prior notice.
GB
23