bca FLOAT Manuel D'utilisation page 16

Installing
1. With the airbag unfolded, lay the ejector in the airbag compartment with the orange release valve
cover facing up (a). The air hose should be fed through the designated opening (b) into the main
storage compartment where the cylinder is kept.
2. Starting on the side with the fixed end of the orange rope, thread the rope downward through the
first slit in the airbag. Thread the rope through the first webbing loop then upward back through the
first slit. Repeat this step with each slit (c) until you reach the ejector tube.
3. Once the threading is complete up to the ejector tube, pull the rope tight. This action will pull the
webbing loops up through the attachment slits in the airbag.
4. Bring rope over ejector tube.
5. Repeat threading technique through remaining slits and webbing loops.
6. Secure the loose end of the orange rope by running it up through the black Velcro loop, then loop
it back down and fold the Velcro flap over it.
7. Repack airbag and close compartment (see above instructions for repacking).
8. Reconnect trigger cable and air hose to cylinder (d).
a
b
c
d
16