InSinkErator F-HC3300C Manuel D'installation page 4

2
INSTALLING THE TAP - HC3300/H3300
A
Property Damage: Do not pinch or break copper tubing.
Do not distort the last 25mm of tubing.
B
Wetting O-ring with water prior to
inserting into brass seat helps hold
ring in place during installation.
C
To ease feeding of tubes through hole, first
insert blue tube with quick-connect attachment
and then insert the remaining tubes.
D
Semi-circular mounting plate should
encircle all descending tubes and
extend beyond sink hole when tight.
4
HC3300/H3300
I
Unpack hot water tap components.
I The recommended installation for this
tap is the tap handle on the right.
The unique design allows the handle
to be fully functional when placed to
the right or left of the hot water tap.
Determine preferred handle placement
before installing.
HC3300/H3300
I
Insert rubber O-ring into groove on
brass seat.
I
Place brass seat, O-ring side down,
over hole in sink or worktop.
HC3300/H3300
I Holding brass seat in place, feed
tubes down through the hole in sink
or worktop until base touches
brass seat.
I
Rotate brass seat until the two retaining
studs fit into the holes on the tap base
and base sits firmly on brass seat.
HC3300/H3300
I From under the sink, place the
semicircular mounting plate onto
the threaded stud.
I
Place hex nut onto the threaded stud.
Ensure tap handle is on preferred side
and that tap head is at desired angle.
I
Insert screwdriver into hole on side of
hex tool (creating a "T"), and use tool
to tighten nut and secure tap.
3
MOUNTING THE TANK
A
Tank must be
mounted level
to ensure
proper operation.
Personal Injury/Property Damage: Tank must be
located within 400mm of tap and within 760mm or
less of a standard earth (grounded) outlet. DO NOT
extend plumbing or electrical lines.
B
Leave 12mm for
hanging tank.
Mount tank vertically in an area that allows clearance
on the underside of the tank for drainage, if
necessary. DO NOT over-tighten screws.
4
CONNECTING TAP TO TANK
A
(1) (2) (3)
Property Damage: Pinched or blocked water lines
may cause damage to the water tank. Check to
make sure tubes are connected properly and are
pushed in as mentioned.
I
Select a spot under the sink to mount
tank vertically within reach of both
plumbing and electrical connections.
The tank should be within 400mm or
less of tap water lines and within
760mm or less of a standard earth
(grounded) outlet.
I While holding tank in place on the spot
selected for installation, use a pencil to
mark locations for 2 hanging screws.
Screws provided are for use in wood studs or
cabinets only. Use wall anchors (not supplied)
for installation into plasterboard.
I
Pre-drill 3mm pilot holes at marks.
I Turn screws into pre-drilled holes,
leaving 6.4mm exposed.
I
Hang the tank on the screws.
I
Tighten the screws with only 1/2
turn clockwise.
I
Without depressing the grey button,
place the snap-connect fitting at the
end of the blue tube onto the left
plastic fitting on the tank, pushing until
it clicks into place. (1)
I
Slip the flexible white tube over
barbed middle fitting and slide down
approximately 12mm. (2)
I
Slip the small white tube over the
far right smooth fitting and slide down
approximately 12mm. (3)
I
Visually check for pinched or
crimped tubes.
Hose clamps are not needed for any of the connections.