Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7. Completely tighten all back panel screws starting with the sides
and continuing with the top, middle and bottom.
P8
P1
P9
P10
P1
P3
8. Turn the cabinet onto its side and fasten the two bolts at each
front corner of the cabinet frame.
9. Using the Allen wrench (provided), completely tighten all
16 cabinet bolts
4
P8
P9
P9
P2
P1
P1
P2
P1
Install Casters or Leveling Legs
(optional)
F14 Hex head bolt (16)
The Gladiator
®
Garageworks Large Mobile GearBox is designed to
either roll on casters, be stationary on leveling legs, or be mounted
on a wall. See "Accessories" to order a Mounting Bracket kit.
IMPORTANT: If you decide to mount the cabinet on Gladiator
GearWall
®
panels or GearTrack
leveling legs or casters.
To install casters:
IMPORTANT: Install the casters on the cabinet bottom with the two
rigid casters on the front of the cabinet and the two swivel casters on
the rear of the cabinet.
1. With the brake toward the inside of the cabinet, align the holes in
a rigid caster mounting plate with the holes in a mounting box at
the front side of the cabinet bottom.
NOTE: The holes in the caster mounting plates will align only
with the intended holes in the cabinet bottom to ensure the
correct placement of the casters.
2. Using four hex head bolts, attach the caster to the cabinet.
3. Repeat steps 1 and 2 for the remaining three casters making sure
to install the other rigid caster on the front and both swivel
casters on the rear.
P1
P2
P1
A
A. Rigid casters
B. Swivel casters
4. Tighten all the hex head bolts.
5. Lock the front casters, and stand the cabinet upright.
NOTE: Locking the casters will help keep the cabinet from
moving while it is being lifted.
6. Unlock the front casters and move cabinet to desired location.
NOTE: To keep the cabinet from rolling, lock the casters.
F14
®
channels, you do not need to install
P3
C
C. Caster mounting box
B
Publicité
Table des Matières
