Assembly Instructions; Tools And Parts; Cabinet Use Requirements; Unpack The Cabinet - Whirlpool GLADIATOR GAWG241DRG Instructions D'assemblage

Tools and Parts

Gather the required tools and parts before starting installation.
Tools Needed:
1/2" Wrench (GearWall
■
or GearTrack ® channel mount)
Phillips-head screwdriver
■
Parts Needed for Standard Mount:
1/2" – 20 x 11/2" Lag screws (4)
■
Parts Supplied for 24" (60.96 cm) Cabinet:
Full-width shelf (1)
■
Mounting bracket (1)
■
1/4"- 20 x 1/2" Carriage bolts (2)
■
Parts Supplied for 30" (76 cm) Cabinet:
Full-width shelves (2)
■
Mounting brackets (2)
■
1/4"- 20 x 1/2" Carriage bolts (4)
■

Cabinet Use Requirements

Intended for use in a garage, storage area, laundry room, etc.
■
Maximum weight limit is 50 lbs (22 kg) for each shelf.
■
Maximum weight limit is 150 lbs (68 kg) for the 24" (60.96 cm)
■
cabinet.
Maximum weight limit is 200 lbs (91 kg) for the 30" (76 cm)
■
cabinet.

Unpack the Cabinet

1. Open the cabinet door.
2. Remove and verify the contents. See "Parts
Supplied" in "Tools and Parts."
3. Dispose of/recycle all packaging materials.
25-Feb-2021 08:06:20 EST | RELEASED

ASSEMBLY INSTRUCTIONS

panel 7/16" Wrench (Standard
®
■
mount)
Blunt Tool
■
1/4" Flat washers (4)
■
1/4"- 20 Hex nuts (2)
■
1/4" Washer (2)
■
1/4"- 20 Hex nuts (4)
■
1/4" Washer (4)
■
Key (1)
■
In some European factories the letter "W" of the part code mentioned herein will be automatically

Install the Cabinet to the Wall

WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
IMPORTANT: Decide if you are going to mount the cabinet
on Gladiator GearWall panels or GearTrack
® ®
on a standard wall. Follow the instructions that apply to your
installation.
1.
Install cabinet to GearWall
or GearTrack
18" (46 cm)
IMPORTANT: Be sure the Gladiator
GearTrack channels are installed with mounting screws in every
®
slot and at every stud location with a maximum of 24" (60.96 cm)
horizontally between screws. If Gladiator
will be used to mount the Welded-Steel Wall GearBox cabinet,
they must be installed
18" (45.72 cm) apart.
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
channels, or
®
panels
®
channels
®
GearWall panels or
® ®
GearTrack channels
® ®
3