Ceado B280 Manuel D'utilisation page 18

18
TROUBLESHOOTING
In case of any malfunction, defect of the appliance or if you suspect any breakage after a fall, unplug
the appliance immediately.
If you are unable to solve the problem referring to the table below, contact an Authorized Service
center.
Only qualified experts should repair the appliance.
We are not liable for any damage caused by repairs not made correctly by unauthorized personnel.
In these cases the warranty does not apply.
Problem
The blender does not start.
The blades do not turn with
the motor on.
Noise and vibration of
container.
Make sure it is plugged in.
•
Make sure the safety circuit breaker is closed.
•
Make sure the switch on the blender (7 Fig. 2) is turned to
•
"ON".
If the problem occurs after a long period of intensive use the
•
motor may have overheated. Wait at least 20 minutes and try
again. If you put the blender in a cool place this will reduce
the waiting time.
If the problem occurs after an overload, the circuit breaker on
•
the motor may have been tripped! Push the button on the
back of the appliance (8 Fig. 2).
Make sure the blades and motor revolve freely.
•
Check that the base/container coupling clutches are in good
•
condition.
Make sure the container is correctly fitted on the base.
•
Make sure the blades and clutches are securely tightened.
•
Check that the base/container coupling clutches are in good
•
condition.
Solution
GB