Transmitter Programming Procedure; 1.1) Initial Operation By The End Customer; 1.2) Learning Additional Transmitters Into The Receivers - Selve i-R Multi Send Notice D'utilisation

Transmitter programming procedure

Transmitter programming procedure
The operating instructions provided with receivers and other trans-
mitters must be complied with at all times.
1.) Transmitter programming procedure

1.1) Initial operation by the end customer

If a transmitter has not yet been learnt into the receiver, you can
programme any transmitter in the SELVE intronic range once the
power supply has been connected.
Press the UP and DOWN buttons on the relevant trans-
mitter. This means the transmitter will be temporarily
learnt.
Now press the PROG button for a short time in order
to programme the transmitter properly.
The transmitter is now permanently programmed and will still
be learnt after the power supply has been interrupted.
Note: For initial operation, no radio command will be decoded
without a temporary transmitter allocation. As long as you have
not permanently saved a transmitter, you can delete the
temporary allocation by disconnecting the power supply.
Important: Please take care not to learn several receivers of an
existing system at the same time, since all receivers can then
only be controlled by one send channel.

1.2) Learning additional transmitters into the receivers

When one transmitter has already been learnt, press
3 sec.
the PROG button for 3 seconds (wait until the transmit-
ter control light flashes once). Then the receiver will be
in programming mode for 1 minute.
57
GB