Wellcare WE-167OBHD Mode D'emploi page 13

lead to overheating and damage. You may refer
to "PREPARING FOR USE" section for more
information.
Always use the side with 4D DWF circular holes
towards your body when the blanket is used as an
over- or an underblanket.
PREPARING FOR USE (please see fig.B1, B2)
When the appliance is used as the electric
overblanket (fig. B1) :
1. Place the blanket (8) flat on the top sheet and
make sure it is without any folds, creases or rucks.
2. Always use the side with 4D DWF circular holes
towards your body.
3. Do not fold the blanket back at the head
position, and do not fold or tuck in any of the
wired areas.
4. Connect the detachable plug-in connector (6) to
the connection box (7). Make sure the controller
(2) is not covered by the sheet, pillow or any
objects.
5. Plug the mains cable (1) to the socket.
6. Additional bedcovers can be placed above
the electric blanket (8) to retain more warmth if
needed.
When the appliance is used as the electric
underblanket (fig. B2) :
1. Use this product as an underblanket only when
the bed size exceeds 140 (W) x 200 (L) cm.
2. Place the blanket (8) flat on the mattress, make
GB
13