Philips PHILISHAVE HS970/33 Mode D'emploi page 5

• Recharging: 60 minutes.
The shaver can also be charged from a 12 - 24 Volts
(DC) supply using cord connector type HP 1957.
(Available from Philips retailers or Authorised Service
Dealers.) Charging from a 12 - 24 Volts (DC) supply
requires approx. 24 hours.
• Regular cleaning of the shaver means that less
battery energy is consumed, so that more shaving
time becomes available.
• The shaver will not be damaged by leaving it
connected to the mains supply after it is fully
charged. However, it is not advisable to charge the
shaver permanently as this would shorten the life
of the rechargeable batteries.
4
5 The green pilot light comes on and
one of the blocks of the charge meter
will start flashing.
If the batteries are empty this will be
the first block.
The red pilot light will remain on until
there is enough energy in the
rechargeable batteries for one
cordless shave (3 minutes).
6 Each time when 20% of the full charge
has been accomplished the next block
of the energy meter will start to flash.
4 Insert the small plug into the
shaver. Ensure that the plug is
pushed fully home. (Note the
indication mark.)
Mains voltages: 100 - 240
Volts. (The shaver adjusts
automatically.)
5
40
20
60
40
20