Cleaning, Care & Maintenance - Buffalo CD969 Mode D'emploi

Cleaning, Care & Maintenance
Always allow to cool before cleaning.
WARNING: Do not allow any water to spill into the appliance when cleaning.
• Use warm, soapy water and a damp cloth to clean the appliance.
• Dry thoroughly after cleaning.
• A BUFFALO dealer or qualified technician should carry out repairs if required.
Troubleshooting
Fault
The appliance is The unit is not switched on
not working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Appliance does Bag not correctly positioned
not remove all
Open end of bag is dirty
the air from the
Bag may be punctured
bag
Incorrect bags used
Bags are not Moisture in bag under the sealing
sealing correctly bar
Incorrect bags used
End of bag not placed above sealing
bar
Sealing Bar requires replacement
Error message Lid in poor contact with chamber
E1 in Digital
Lid Gasket distorted or broken
Display
Internal system leak
Error message Safety switch / electronic fault
E2 in Digital
Display
NOTE: Sealing bar replacement is not covered under warranty
CD969_ML_A5_v3_20181031.indb 5
Probable Cause Solution
Check the unit is plugged in correctly and
switched on
Call BUFFALO agent or qualified Technician
Replace the plug fuse
Check power supply
Call BUFFALO agent or qualified technician
Open lid and reposition bag
Clean bag
Replace bag
Call Vacuum Pack machine supplier
Ensure inside of the bag is dry and free from
moisture where it is to be sealed
Call Vacuum Pack machine supplier
Move end of bag over sealing bar
Call BUFFALO agent or qualified technician
Clean lid gasket and chamber
Replace the lid gasket
Call BUFFALO agent or qualified technician
Call BUFFALO agent or qualified technician
UK
5
2018/10/31 16:02