Package Contents; Description (Fig. A) - DeWalt DW580K Manuel D'utilisation

E N G L I S H
10 Secure workpiece
Use clamps or a vice to hold the workpiece. It is
safer and it frees both hands to operate the tool.
11 Do not overreach
Keep proper footing and balance at all times.
12 Avoid unintentional starting
Do not carry the plugged-in tool with a finger on
the switch. Be sure that the switch is released
when plugging in.
13 Stay alert
Watch what you are doing. Use common sense.
Do not operate the tool when you are tired.
14 Disconnect tool
Shut off power and wait for the tool to come to
a complete standstill before leaving it
unattended. Unplug the tool when not in use,
before servicing or changing accessories.
15 Remove adjusting keys and wrenches
Always check that adjusting keys and wrenches are
removed from the tool before operating the tool.
16 Use appropriate tool
The intended use is laid down in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which it
was intended.
Warning! The use of any accessory or
attachment and performance of any operation
with this tool, other than those recommended in
this instruction manual may present a risk of
personal injury.
17 Do not abuse cord
Never carry the tool by its cord or pull it to
disconnect from the socket. Keep the cord away
from heat, oil and sharp edges.
18 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Inspect the tool cords at regular
intervals and, if damaged, have them repaired by
an authorized D WALT repair agent. Inspect the
E
extension cords periodically and replace them if
damaged. Keep all controls dry, clean and free
from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for damage
to ensure that it will operate properly and perform
its intended function.
en - 3
Check for misalignment and seizure of moving
parts, breakage of parts and any other conditions
that may affect its operation. Have damaged
guards or other defective parts repaired or replaced
as instructed. Do not use the tool if the switch is
defective. Have the switch replaced by an
authorized D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.

Package contents

The package contains:
1 Dry Diamond Drilling Machine
1 Side handle
1 Kitbox
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

Your D WALT Dry Diamond Drilling machine has
E
been designed for drilling into masonry materials
such as brick breezeblock, etc. For drilling concrete,
a wet drilling rig must be used (DW590K).
1 Variable speed switch
2 Lock-on button (DW590K)
3 53 mm side handle mounting
4 Spindle
5 Side handle
6 Two gear selector
7 Carbon brush access cover
Torque limiting clutch
Your dry diamond drilling machine is equipped with
a torque limiting clutch that reduces the maximum
torque reaction transmitted to the operator in case
of jamming of a core bit. This feature also prevents
the gearing and electric motor from stalling.
The torque limiting clutch has been factory-set and
cannot be adjusted.
16