Numark MIXTRACK PRO 3 Guide D'utilisation page 3

User Guide (English)
Introduction
Box Contents
MIXTRACK PRO 3
USB Cable
Software Download Card
User Guide
Safety & Warranty Manual
Support
For the latest information about this product (system requirements, compatibility information, etc.)
and product registration, visit numark.com.
For additional product support, visit numark.com/support.
Quick Start / Connection Diagram
1. Place MIXTRACK PRO 3 on a flat, stable surface.
2. Make sure all devices are turned off and all faders and gain knobs are set to "zero".
3. If using a microphone, connect it to MIXTRACK PRO 3's mic input.
4. Connect MIXTRACK PRO 3's outputs to power amplifiers, tape decks, and/or other audio
sources.
5. Plug all devices into AC power and connect MIXTRACK PRO 3's USB port to a computer's
USB port using the included USB cable.
6. When powering everything on, power on your devices in the following order:
• Your computer
• Any amplifiers, speakers, or output devices
7. Locate the Serato DJ Intro installation card in the box to download and install the software.
8. Open your software program and load music to the decks.
9. Start DJ'ing!
10. When powering everything off, power off your devices in the following order:
• Any amplifiers, speakers, or output devices
• Your computer
* not included
COMPUTER*
SPEAKERS*
HEADPHONES*
MICROPHONE*
3