Automatic Degreasing By Catalysis - SCHOLTES CJ 32G W Mode D'emploi

In the event of a power outage, the oven can be lighted manually following the instructions provided in the section entitled
"The Oven and Grill Knob." The electronic lighting device for the oven burner must not be activated for more than 15
seconds. If after 15 seconds the burner has not been lighted, release the button, open the oven door and wait for at least
one minute before trying to light the burner again.
T T T T T he Grill Oper he Grill Oper he Grill Oper he Grill Oper he Grill Opera a a a a ting Light ting Light ting Light ting Light ting Light
This light comes on when any of the electrical heating elements in the oven have been turned on.
Timer Timer Timer
Timer Timer
To use the timer, it must be wound using the knob. Turn the knob almost one full turn in the clockwise direction
turn the knob back , and set the time by positioning the number (minutes) on the knob dial beneath the mark on the
control panel.
Caution Caution Caution Caution Caution
Keep children away from the oven door when in use because it becomes very hot.

Automatic degreasing by catalysis

On certain models, the interior panels of the oven are coated with a porous enamel, known as catalytic enamel.
This enamel coating has the property of destroying the grease spots that splash onto the oven interior during
cooking under the effect of heat.
The temperature of the oven lining panels has to be in excess of 170° for this grease "oxidation" process to take
place.
The porosity of the catalytic enamel increases the heat exchange surface necessary for the oxidation of these
grease spots to take place by catalysis.
When cooking is complete, if the interior panels of your oven are still dirty, leave the oven on and empty with the
oven door shut, and set the temperature knob to the maximum value, for 60-90 minutes, depending on the
degree of soil inside the appliance. You may also help in the removal of any large pieces of food residue or splashes
of grease using a little hot water and a soft brush.
Warning: The catalytic enamel is resistant but you should however avoid:
- scratching the surface of the enamel coating with sharp objects (such as knives, for example)
- using abrasive detergents or products.
In actual fact, the automatic degreasing properties of this enamel coating would be damaged irreversibly.
This enamel coating is resistant enough to allow for the sliding of several accessories (large grid, dripping pan,
turnspit assembly) without damaging the enamel. Do not worry if you see light white traces appear on the sliding
surfaces of these accessories.
- 28 -
. Then,