Features And Controls - Murray 1695859 Manuel D'utilisation

A
B
Snowthrower Controls
SNOWTHROWER CONTROLS
A. Speed Select Lever — Allows the operator to use one of six
(6) forward and two (2) reverse speeds. To shift, move speed
select lever to desired position.
NOTICE: Do not move speed select lever while Traction
Control is engaged. This may result in severe damage to
drive system.
B. Auger Control Lever — Used to engage and disengage the
auger and impeller. To engage push down, to disengage
release.
C. Chute Rotation Crank — Used to rotate the discharge chute
to the left or right.
D. Chute Deflector Wing Nut — Used to control the angle of
the chute deflector (up or down).
F
C
I
G
E. Free-Hand
F. Traction Control Lever — Used to propel snowthrower
G. Skid Shoe — Used to adjust ground clearance of auger
H. Clean-Out Tool — Used to remove snow and debris from the
I. Headlight — Used to operate the snowthrower in poor

FEATURES AND CONTROLS

E
1
D
H
TM
Control — After engaging the traction control
(left hand) and auger control (right hand), allows the operator
to release the auger control lever to use the other controls.
forward or reverse. Push down to engage, release to
disengage.
housing.
discharge chute and the auger housing.
lighting conditions.
2
17