Panasonic EYFR02 Instructions D'utilisation page 12

Installing the Assembly Qualifier
Installation method
Mount the Assembly Qualifier securely with screws using the four mounting holes.
NOTE
Before mounting the Assembly Qualifier, test it where you plan to install it to ensure
that there are no communications issues.
CAUTION
Verify that the Assembly Qualifier is not affected by other wireless equipment before
mounting it.
III
. OPERATION
Registering the tool with the Assembly Qualifier
● Preparing the Assembly Qualifier
1. Connect the power cord to the Assembly Qualifier.
. Plug the power cord into a wall outlet.
3. Turn on the Assembly Qualifier.
All indicators will turn on and off, leaving only the power indicator on.
4. Insert a soft key into the key lock and turn to the left.
The power indicator will flash, and the Assembly Qualifier will enter tool
registration standby mode.
● Preparing the tool to be registered
1. Operate the tool so that all the panel lights are off (if any panel lights are on).
. Pull the tool's trigger.
Once the tool has been registered, the Assembly Qualifier's fastening accept
signal will turn on.
3. Turn the Assembly Qualifier's soft key to the right.
The power indicator will turn on and the Assembly Qualifier will enter receive
mode, completing the registration process.
CAUTION
The registration procedure should be performed away from other transmitter-
equipped tools. When registering multiple tools, do so one pair at a time. Failure to
do so may cause an unintended tool to be registered with the Assembly Qualifier.
- 1 -