Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. Configure the settings as desired.
• Enter values and select settings.
• File menu
Function description
Function description
Time during which to invalidate the next
Time during which to invalidate the next
(A)
(A)
reception (so that cycles are not counted
reception (so that cycles are not counted
twice)
twice)
(A)
(B) Fastening accept signal relay output time*
(B) Fastening accept signal relay output time*
(B)
(C)
(C) Fastening reject signal relay output time*
(C) Fastening reject signal relay output time*
(D)
Sets the beep mode to any of three options.
Sets the beep mode to any of three options.
1 Accept and Reject: Fastening accept
1 Accept and Reject: Fastening accept
(E)
(D)
(D)
and fastening reject
and fastening reject
(F)
2 Accept only: Fastening accept only
2 Accept only: Fastening accept only
(G)
3 Reject only: Fastening reject only
3 Reject only: Fastening reject only
Sets the relay output method to either of
Sets the relay output method to either of
two options.
two options.
(E)
(E)
1 Latching: Output continuously.
1 Latching: Output continuously.
2 Momentary: Output for duration
2 Momentary: Output for duration
defined by relay output time.
defined by relay output time.
(F) Sets the frequency to any of 1 channels.**
(F) Sets the frequency to any of 1 channels.**
(G) Displays the registered tool ID.
(G) Displays the registered tool ID.
* Valid only when (E) has been set to 2 ("Momentary").
Setting a long relay output time slows the reception process.
** When configuring settings
• When changing the frequency (channel) with the dedicated
configuration software (Device Programmer), the tool may
not be able to communicate with the Assembly Qualifier.
If you encounter this difficulty after the Assembly Qualifier
has been registered, be sure to remove and then reattach
the battery pack.
• Because the Assembly Qualifier must search for the tool,
the process of establishing communications takes to 5
seconds after the frequency (channel) is changed for the
first time.
1 Creates a new file.
2 Opens a previously created file.
3 Saves the current settings.
4 Saves the current settings as a new file.
5 Opens recently used files.
6 Exits the Device Programmer application.
- 10 -
Initial
Initial
setting
setting
0 (0 sec)
0 (0 sec)
0
0
(0. sec)
(0. sec)
0
0
(0. sec)
(0. sec)
Accept and
Accept and
Reject
Reject
Momentary
Momentary
1
1
0000
0000
Publicité
Table des Matières
