Witter AD41C Instructions De Montage

MATERIALS
A 1 Cross Bar
C 1 Centre Strut with European facing to 94/20/EC A50-1
D 4 M10 x 100 x 1.5mm Bolts, Lock Washers, 2 Nuts and 6 Flat Washers (30mm O.D.)
E 1 Left Hand Side Arm
F 1 Right Hand Side Arm
G 4 M12 x 40 x 1.75mm Bolts, Nuts and Lock Washers
H 2 M12 x 90 x 1.75mm Bolts and Nyloc Nuts
Bushes (28mm long – 25mm O.D.)
H1 2
U – Nuts
J 2
CB 2 M16 x 50 x 2.0mm Coupling Bolts, Nuts and Lock Washers
EP 1 Electrical Plate
FITTING
1. Remove rear trim panels. Remove bumper (6 nuts each side inside vehicle, 2 torx head screws behind wheel
arch liners – also retained with torx head screws, 5 torx head screws along lower edge of bumper. Pull out
bumper tips and then pull bumper rearwards). Remove bumper beam.
2. Temporarily lower exhaust hangers and remove heat shield. Remove tape from forward most mounting points
(above and below chassis). Insert Side Arms (E) and (F) into chassis rails and loosely attach using Bolts (D).
3. Loosely attach Cross Bar (A) to Side Arms (E) and (F) using Bolts (G). Tighten all bolts. Cut bumper as shown
below. Re – mount heat shield and exhaust. Re-fit bumper using U – nuts (J) for lower bumper fixings.
Attach Centre Strut (C) and Electrical Plate (EP) to Cross Bar (A) using Bolts (H) and Bushes (H1). Tighten
Bolts.
Note: This towbar must be used with either a Witter Towball (part number Z1) or Class A50-1 or A50-X towball dimensionally
Conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar. Also approved for use with Witter
detachable towball kit (part no. ZR2K000).
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm , M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY
Fitting
Instructions
µW0001AD41C-FIT$0211051900006Ä
W0001AD41C-FIT$021105190000
www.witter-towbars.co.uk
AD41C
TOWBAR
For AUDI A4
(2001-2004)
Issue 2