Health And Safety; Operating Requirements; Recommended Hydraulic Oil - Belle Group 188-00010 Manuel De L'opérateur

GB
Vibration
Some vibration from the cutter operation is transmitted through the handle to the operator's hands. The Belle Group saw has been
specifi cally designed to reduce hand/arm vibration levels.
PPE (Personal Protective Equipment).
Suitable PPE must be worn when using this equipment i.e. Safety Goggles, Gloves, Ear Defenders, Dust Mask and Steel Toe capped
footwear. Wear clothing suitable for the work you are doing. Tie back long hair and remove any jewellery which may catch in the
equipment's moving parts.
Dust
The cutting process will occasionally produce dust, which may be hazardous to your health. Always wear a mask that is suited to the
type of dust being produced.
GB
BLADE PERFORMANCE REQUIREMENTS
Any blade from your supplier must meet the following design criteria. Using blades on this saw that don't meet these requirements can
cause equipment damage and/or personal injury.
1. Use blades that meet applicable industrial safety code specifi cations.
2. Use blades that are approved by the blade manufacturer for the material to be cut.
3. Use approved dry cutting type blades in dry cutting operations and approved wet cutting type blades in wet cutting operations.
4. Do not exceed either the maximum operating speed of 4100 rpm or the blade manufacturer's rated speed. Blades must be speed
tested to ANSI B7.1 safety code specifi cations.
5. When using abrasive blades, always use blades with mounting blotters on both sides. Remove drive pin from arbor fl ange before
mounting an abrasive blade.
HYDRAULIC POWER SOURCE REQUIREMENTS
The hydraulic power source must meet the following design criteria.
1. The fl ow must not exceed 8 gpm and the pressure relief valve must not exceed 2500 psi @ 8 gpm. Failure to comply could cause
excessive blade rpm and/or overpressurizing the system, resulting in equipment damage and/or personal injury.
2. The hydraulic power source must meet the hydraulic requirements on Page 4.

RECOMMENDED HYDRAULIC OIL

Viscosity
Flash Point
Pour Point
Many types of compatible hydraulic oil are available through your local dealer/distributor. As an original equipment manufacturer, Belle
uses a Grade ISO VG 32 hydraulic turbine oil. Hydraulic oil types are too numerous to list in this manual. If you have any question
concerning the type of oil suitable for Saw operation, please consult your local dealer or The Belle Group for details.

Health and Safety

Operating Requirements

140-225 SUS @ 100°F
40 min. SUS @ 210ºF
340ºF min.
-30ºF min.
(28-45 cSt @ 38°C)
(8 min. cSt @ 99ºC)
(170ºC min.)
(-34ºC min.)
6